Advertisement
TEMP INTERMITTANT: WHY DOES MY TEMP/HUMIDITY READING COME AND GO?
•
RF (radio frequency) communication may come and go occasionally. This can be normal in
some environments (e.g. moister climates).
•
If a sensor goes out, please wait 2-4 hours for it to reconnect on its own. Please be patient
– these stations can reconnect on, after many hours out.
•
RF (radio frequency) communication is not always 100% on. Certain temporary conditions
can cause it to go out for a time (e.g. 100% humidity).
If a miss happens:
•
If sensor loses connection to the station for any reason, the station will show dashes after 30
minutes.
•
The station will search for 5 minutes every hour to reconnect with sensor.
•
Be sure you have good batteries.
Try this:
•
Bring your sensor within 10 feet of your station and make sure it is connected to the station.
•
After 15 minutes move the sensor into the next room with a wall between the sensor and the
station for 1 hour.
•
If there is no loss of signal in that hour, move the sensor just outside.
•
Continue moving the sensor back to its original location.
•
If you lose connection, look for sources of
WHY AM I GOING THROUGH BATTERIES QUICKLY?
•
Test a new set of
batteries.
•
When the batteries fail, please note the date and voltage again. This is helpful in determining
the problem.
•
Check for leaking batteries, which may damage the sensor.
HOW DO I CHANGE BETWEEN FAHRENHEIT AND CELSIUS?
•
On your station enter the
temperature display on the station.
HOW DO I VIEW OTHER SENSORS ON MY STATION?
Explanation: The forecast station will accommodate up to three remote
Compatible sensor are TX-21U-IT, TX29UDTH-IT.
•
Press and release the SET/CH button to view channel 1, 2 or 3 on the display when multiple
transmitters are used.
Note: You cannot change channels if only one transmitter is connected.
batteries.
Write down the date of installation and the voltage of the
program menu
interference.
to select 12h = Fahrenheit and 24h = Celsius
outdoor
transmitters.
6 |
P a g e
Advertisement
