Table of Contents
Advertisement
•
If batteries are good, replace the outdoor sensor.
•
If your temperature is fine but your humidity is reading "HI" or "LO" or dashes, your humidity
may be below 10% Relative Humidity. Your sensor does not read below 10% humidity.
TEMPERATURE INTERMITTANT: WHY DOES MY TEMP/HUMIDITY
•
RF (radio frequency) communication may come and go occasionally. This can be normal in
some environments (e.g. moister climates).
•
If a sensor goes out, please wait 2-4 hours for it to reconnect on its own. Please be patient
– these stations can reconnect on, after many hours out.
•
RF (radio frequency) communication is not always 100% on. Certain temporary conditions
can cause it to go out for a time (e.g. 100% humidity).
If a miss happens:
•
If sensor loses connection to the station for any reason, the station will show dashes after 30
minutes.
•
The station will search for 5 minutes every hour to reconnect with sensor.
•
Be sure you have good batteries. Manually search for your sensor by holding the PLUS (+) or
+/SEARCH button for three seconds.
Try this:
•
Bring your sensor within 10 feet of your station and make sure it is connected to the station.
•
After 15 minutes move the sensor into the next room with a wall between the sensor and the
station for 1 hour.
•
If there is no loss of signal in that hour, move the sensor just outside.
•
Continue moving the sensor back to its original location.
•
If you lose connection, look for sources of
WHY AM I GOING THROUGH BATTERIES QUICKLY?
•
Test a new set of
batteries.
•
When the batteries fail, please note the date and voltage again. This is helpful in determining
the problem.
•
Check for leaking batteries, which may damage the sensor.
HOW DO I CHANGE BETWEEN FAHRENHEIT AND CELSIUS?
•
On your station enter the
on the station.
READING COME AND GO?
batteries.
Write down the date of installation and the voltage of the
program menu
interference.
to select Fahrenheit or Celsius temperature display
9 |
P a g e
Hide quick links:
Advertisement
Table of Contents
