Table of Contents
Advertisement
TEMP ACCURACY: WHY DOES MY THERMO-HYGRO SENSOR READ
•
The thermo-hygro sensor reads the environment. Since your Temperature/Humidity
readings come from the Wind/TH sensor they may occasionally be inaccurate if the sunlight
hits the sensor.
•
If this is a common occurrence you can purchase an LTV-TH2 sensor and replace the
Temperature/Humidity Reading from the Wind/TH sensor.
HOW TO REPLACE THE TH READING FROM THE WIND TH SENSOR WITH
The new Wind Speed, Wind Direction Sensor with Temperature/Humidity may cause inaccurate
temperature readings in some locations. Because of this, you have the option to remove the TH
sensor reading (from the LTV-WSDTH01) and adding an additional TH sensor to read in the
OUTDOOR area of the display.
1. Press SENSOR button once Station ID will show.
2. Press SENSOR button again ID WTH123 THW SENSOR will show.
3. Hold the MINUS (-) button for 5 seconds while viewing ID to delete ID WTH123.
To add a separate LTV-TH2 sensor:
• After deleting the TH sensor built into the Wind Sensor (ID: WTH123), press the SENSOR
button on the station to view ID, then press the + (PLUS) button to search.
• Press the TX button on the add-on sensor.
• Sensor Icon
WHAT DOES A READING OF "HI" OR "LO" MEAN?
•
If your outdoor temperature reading shows "HI" or "LO", check that your
•
Overpower or underpowered batteries can cause this reading.
•
If batteries are good, replace the outdoor sensor.
•
If your temperature is fine but your humidity is reading "HI" or "LO" or dashes, your humidity
may be below 10% Relative Humidity. Your sensor does not read below 10% humidity.
TEMP INTERMITTANT: WHY DOES MY TEMP/HUMIDITY READING COME
•
RF (radio frequency) communication may come and go occasionally. This can be normal in
some environments (e.g. moister climates).
INACCURATELY?
AN
will show to indicate reading is coming from separate TH sensor.
AND GO?
LTV-TH2?
batteries
are good.
19 |
P a g e
Advertisement
Table of Contents
