Advertisement
Your station is designed for flexible placement on a desk or countertop, or to position on the
wall.
•
Best reception occurs when only one wall is between your station and your sensor outside.
•
Position you station six feet from other electronics and wireless devices. If you suspect RF
(radio frequency) interference, simply move your weather station a few feet.
WHAT IS DISTANCE | RESISTANCE | INTERFERENCE?
Distance:
•
The maximum transmitting range in open air is over 330 feet (100 meters) between your
sensor and your station.
•
Consider the signal path from your station to your sensor as a straight line.
•
Consider the distance the station is from other electronics in the home.
Resistance:
•
Each obstacle: walls, windows, vegetation, stucco, concrete, and large metal objects will
reduce the effective signal range by about one-half.
•
Mounting your sensor on a metal fence can significantly reduce the effective signal range.
Interference:
•
Consider electronics in the signal path between the sensor and your station.
•
Simple relocation of the sensor or the station may correct an interference issue.
•
Windows can reflect the radio signal.
•
Metal will absorb the RF (radio frequency) signal.
•
Stucco held to the wall by a metal mesh will cause interference.
•
Transmitting antennas from: ham radios, emergency dispatch centers, airports, military
bases, etc. may cause interference.
•
Electrical wires, utilities, cables, etc. may create interference if too close.
HOW DO I VIEW MY MIN AND MAX TEMPERATURE/HUMIDITY READINGS?
1. Press and release the MIN/MAX/+ button both the Minimum Indoor Temperature and
Outdoor Temperature and Humidity will show. Press and release the MIN/MAX/+ button.
2. Both the Maximum Outdoor Temperature and Outdoor Temperature and Humidity will show.
Press and release the MIN/MAX/+ button to return to the current readings.
Note: If using multiple outdoor sensors press and release the SET/CH button to get to the
desired sensor and then press the MIN/MAX/+ button to show each channel's recorded
readings.
HOW DO I RESET THE TEMPERATURE/HUMIDITY READINGS?
Reset: Press and hold the MIN/MAX/+ button for 5 seconds and all the Minimum and Maximum
readings will be reset.
WHERE TO I PLACE MY STATION?
3 |
P a g e
Advertisement
