How To Replace The Th Reading From The Wind Th Sensor With An Tx141Th-Bv3; What Does A Reading Of "Hi" Or "Lo" Mean; Temp Intermittant: Why Does My Temp/Humidity Reading Come And Go - La Crosse Technology S81120 Faqs

HOW TO REPLACE THE TH READING FROM THE WIND TH
The new Wind Speed, Wind Direction Sensor with Temperature/Humidity may cause inaccurate
temperature readings in some locations. Because of this, you have the option to remove the TH
sensor reading (from the TX145WSDTH) and adding an additional TH sensor to read in the
OUTDOOR area of the display.
1. From normal time display; Press the MINUS button -Outdoor Temp/Humidity will flash.
2. Hold the MINUS button 5 seconds to delete Temp Humidity reading only (From WIND/TH or
TX141THB-v3 sensor). Station will search for Temp Humidity reading (from any sensor).
3. Press TX button on the add-on sensor to force a signal.
Note: If the Display could not receive signal from TX141THB-v3 in the 3 mins, the Display will
accept the Wind/TH sensor as the Outdoor sensor instead. With such, in case the user decides
to switch back from TX141THB-v3 to Wind/TH, there is still a way.
Note: The Outdoor Sensor icon will only show when the Outdoor temperature/humidity reading
is coming from the add-on TH sensor. Only 1 TH reading can show.

WHAT DOES A READING OF "HI" OR "LO" MEAN?

• If your outdoor temperature reading shows "HI" or "LO", check that your batteries are good.
• Overpowered or underpowered batteries can cause this reading.
• If batteries are good, replace the outdoor sensor.
• If your temperature is fine but your humidity is reading "HI" or "LO" or dashes, your humidity
may be below 10% Relative Humidity. Your sensor does not read below 10% humidity.
TEMP INTERMITTANT: WHY DOES MY TEMP/HUMIDITY READING
• RF (radio frequency) communication may come and go occasionally. This can be normal in
some environments (e.g. moister climates).
• If a sensor goes out, please wait 2-4 hours for it to reconnect on its own. Please be patient
– these stations can reconnect on, after many hours out.
• RF (radio frequency) communication is not always 100% on. Certain temporary conditions
can cause it to go out for a time (e.g. 100% humidity).
If a miss happens:
• If sensor loses connection to the station for any reason, the station will show dashes after 30
minutes.
• The station will search for 5 minutes every hour to reconnect with sensor.
• Be sure you have good batteries. Manually search for your sensor.
SENSOR WITH AN TX141TH-BV3?
COME AND GO?
13 | P a g e