EPS Bio Technology EMV3.1 User Manual page 31

Apply blood to the edge of
the test strip.
Be sure to get enough blood
on strip to make it to the
confirmation window.
5. Gently squeeze and/or 6. Touch the blood drop at the tip of the
massage your fingertip transparent window of the test strip.
until a round drop of blood Do not put blood on top of the strip.
on your fingertip. Be sure to get enough blood on the
strip's reaction zone. Otherwise, an
inaccurate reading may result.
7. The meter starts to count down from
5 seconds and speaks the result.
Note: 1. Please make sure to apply blood when the blood drop appears on the display.
2. Please check if the result on the display is the same as audible result.
Do not apply blood on
top of the test strip.
Not enough blood on
strip to get a test result.
8. Press power button to repeat
the test result. Or you can also
press C button or M button to
set the volume before repeating
the result.
9. Remove the test strip and the
meter turns off automatically.
31