Page 1
Dash Disassembly – Kit Assembly KIT FEATURES – – Two finishes available: 95-7510 = Black, 95-7510HG = Gloss Black KIT COMPONENTS TOOLS REQUIRED CAUTION: Metra recommends disconnecting the negative battery terminal before beginning any installation. All accessories, switches, and especially air bag indicator lights must be plugged in before reconnecting the battery or cycling the ignition.
Page 2
95-7510 Dash Disassembly (Figure A) (Figure D) (Figure B) (Figure E) (Figure C) (Figure F)
Page 3
95-7510 Dash Disassembly (Figure H) (Figure K) Continue to kit assembly REMOVE (2) SCREWS PER SIDE (Figure G) (Figure I) (Figure J) (Figure L)
Page 4
95-7510 Kit Assembly Double DIN or stacked ISO radio Kit Preparation provisions (Figure A) (Figure A) Continue to Interface Installation (Figure B) (Figure B)
Page 5
95-7510 Interface Installation Warning: failure to insert the HVAC cables into the correct location will cause Note: start the vehicle and Note: reverse output is NOT damage to the interface and make the display and HVAC controls hold the “AUTO” button for 10-...
Page 6
95-7510 Display Customization *Note: Refer also to the instructions included with the aftermarket radio. rear defrost A/C Mode A/C Mode MODE TILT OPEN A/C Mode SET TEXT SET TEXT A/C Mode AMB TEMP ON OFF, AMB TEMP C F SET TIME 12/24H...
Page 8
INSTALLATION INSTRUCTIONS FOR PART 95-7510 NOWLEDGE IS OWER Enhance your installation and fabrication skills by enrolling in the most recognized and respected mobile electronics school in our industry. Log onto www.installerinstitute.com or call 800-354-6782 for more information and take steps toward a better tomorrow.