Table of Contents
Advertisement
Prestige 782R G.SHDSL Router
FIELD
Bridge
Edit PPP Options
Rem IP Addr
Edit IP/IPX/Bridge
Edit ATM Options
Session Options
Edit Filter Sets
When you have completed this menu, press [ENTER] at the prompt "Press [ENTER] to confirm or [ESC]
to cancel" to save your configuration or press [ESC] to cancel and go back to the previous screen.
4.1.3 Outgoing Authentication Protocol
For obvious reasons, you should employ the strongest authentication protocol possible. However, some
vendor's implementation includes specific authentication protocol in the user profile. It will disconnect if
the negotiated protocol is different from that in the user profile, even when the negotiated protocol is
stronger than specified. If the peer disconnects right after a successful authentication, make sure that you
specify the correct authentication protocol when connecting to such an implementation.
4.1.4 Editing PPP Options
To edit the remote node PPP options, move the cursor to the Edit PPP Options field in Menu 11.1 –
Remote Node Profile, and use [SPACE BAR] to select Yes. Press [ENTER] to open Menu 11.2, as shown
next.
4-4
DESCRIPTION
When bridging is enabled, your Prestige will forward any
packet that it does not route to this remote node;
otherwise, the packets are discarded.
To edit the PPP options, move the cursor to this field.
Use [SPACE BAR] to select Yes and press [ENTER].
This will take you to Menu 11.2 – Remote Node PPP
Options. For more information on configuring PPP
options, see the section Editing PPP Options.
This is a required field if Route is set to IP. Type the IP
address of the remote gateway.
Press [SPACE BAR] to select Yes and press [ENTER]
to display Menu 11.3 – Remote Node Network Layer
Options.
Press [SPACE BAR] to select Yes and press [ENTER]
to display Menu 11.6 – Remote Node ATM Layer
Options.
Use [SPACE BAR] to choose Yes and press [ENTER]
to open Menu 11.5 to edit the filter sets. See the
Remote Node Filter section for more details.
OPTIONS
Yes/No
Yes
192.168.10.1
(example)
No/Yes
No/Yes
No
(default)
Remote Node Configuration
Advertisement
Table of Contents
