Table of Contents
Advertisement
Press Space Bar to Toggle.
The following table describes how to configure your TCP/IP filter rule.
FIELD
Filter #
Filter Type
Active
IP Protocol
IP Source Route
Destination:
IP Addr
IP Mask
Filter Configuration
Menu 21.1.1 - TCP/IP Filter Rule
Filter #: 1,1
Filter Type= TCP/IP Filter Rule
Active= Yes
IP Protocol= 6
Destination: IP Addr= 0.0.0.0
Source: IP Addr= 0.0.0.0
TCP Estab= No
More= No
Action Matched= Drop
Action Not Matched= Check Next Rule
Press ENTER to Confirm or ESC to Cancel:
Figure 8-6 Menu 21.1.1 – TCP/IP Filter Rule
Table 8-3 TCP/IP Filter Rule Menu Fields
DESCRIPTION
This is the filter set, filter rule coordinates, i.e., 2, 3 refers
to the second filter set and the third filter rule of that set.
Use [SPACE BAR] to toggle between types of rules.
Parameters displayed for each type will be different.
This field activates/deactivates the filter rule.
This is the upper layer protocol, e.g., TCP is 6, UDP is 17
and ICMP is 1. The value must be between 0 and 255.
If Yes, the rule applies to packet with IP source route
option; or else the packet must not have the source route
option. The majority of IP packets do not have source
route.
Type the destination IP address of the packet you want to
filter. This field is ignored if it is 0.0.0.0.
Type the IP mask to apply to the Destination: IP Addr
IP Source Route= No
IP Mask= 0.0.0.0
Port #= 137
Port # Comp= Equal
IP Mask= 0.0.0.0
Port #= 0
Port # Comp= None
Log= None
Prestige 782R G.SHDSL Router
OPTIONS
TCP/IP Filter Rule/
Generic Filter Rule/
IPX Filter Rule
Yes/No
0 to 255
Yes/No
IP address
IP mask
8-7
Advertisement
Table of Contents
