Table of Contents
Advertisement
Step 2.
Move the cursor to the Edit IP/IPX/Bridge field, then press the [SPACE BAR] to select Yes
and press [ENTER] to open Menu 11.3 - Network Layer Options.
VPI/VCI (LLC-mux or PPP/PPPoE Encap):
VPI #= 0
VCI #= 35
IP Options:
Rem IP Addr: 0.0.0.0
Rem Subnet Mask= 0.0.0.0
IP Address Assignment = Dynamic
My WAN Addr= 0.0.0.0
Single User Account= Yes
Metric= 2
Private= No
RIP Direction= None
Multicast= None
IP Policies=
The following table describes the bridging-specific parameters in Menu 11.1 - Remote Node Profile and
Menu 11.3 - Remote Node Network Layer Options menus.
Table 7-2 P645R Remote Node Network Layers Menu Bridge Options
FIELD
Bridge (menu 11.1)
Edit IP/IPX/Bridge
(menu 11.1)
Dial-On-Broadcast
(menu 11.3)
Ethernet Addr
Timeout (min) (menu
11.3)
Bridging Setup
Menu 11.3 - Remote Node Network Layer Options
Version= RIP-1
Enter here to CONFIRM or ESC to CANCEL:
Figure 7-2 Menu 11.3 - Remote Node Bridging Options
Make sure this field is set to Yes.
Press the [SPACE BAR] to change it to Yes and press [ENTER] to go to Menu
11.3 –Remote Node Network Layer Options.
This field is necessary for your Prestige on the caller side LAN. When set to Yes,
any broadcasts coming from the LAN will trigger your Presige to make a call to
this remote node. If it is set to No, your Prestige will not make the outgoing call.
In this field, enter the time (number of minutes) that you wish your Prestige 645R
to retain the Ethernet Addr information in its internal tables while the line is down.
If this information is retained, your Prestige 645R will not have to recompile the
tables when the line is brought back up.
Prestige P645 ADSL Internet Access Router
IPX Options :
Rem LAN Net #= 00000000
My WAN Net #= 00000000
Hop Count= 1
Tick Count= 2
W/D Spoofing(min)= N/A
SAP/RIP Timeout(min)=N/A
Dial-On-Query= N/A
Bridge Options:
Dial-On-Broadcast= N/A
Ethernet Addr Timeout(min)= 0
DESCRIPTION
7-3
Advertisement
Table of Contents
Troubleshooting
