Bridge Static Route Setup; Figure 6-1 Menu 11.3 - Remote Node Bridging Options; Prestige 650Me Adsl Bridge; Table 6-1 Remote Node Bridge Options - ZyXEL Communications Prestige 650ME User Manual

Prestige 650ME ADSL Bridge

IP Options:
FIELD
Bridge (menu 11.1)
Edit IP/Bridge (menu
11.1)
Ethernet Addr Timeout
(min.) (menu 11.3)
When you have completed this menu, press [ENTER] at the prompt "Press [ENTER] to confirm or [ESC]
to cancel" to save your configuration or press [ESC] to cancel and go back to the previous screen.

6.2.2 Bridge Static Route Setup

Similar to network layer static routes, a bridging static route tells the Prestige the route to a node before a
connection is established. You configure bridge static routes in menu 12.3.1 (go to menu 12, choose option
3, then choose a static route to edit) as shown next.
6-2
Menu 11.3 - Remote Node Network Layer Options
IP Address Assignment= Static
Rem IP Addr: 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
NAT= SUA Only
Metric= 2
Private= No
RIP Direction= Both
Version= RIP-2B
Multicast= IGMP-v2
IP Policies=
Press ENTER to Confirm or ESC to Cancel:
Figure 6-1 Menu 11.3 – Remote Node Bridging Options

Table 6-1 Remote Node Bridge Options

Make sure this field is set to Yes.
Press [SPACE BAR] to select Yes and press [ENTER] to display menu 11.3.
Type the time (in minutes) for the Prestige to retain the Ethernet address
information in its internal tables while the line is down. If this information is
retained, your Prestige will not have to recompile the tables when the line
comes back up.
Bridge Options:
Ethernet Addr Timeout (min)= 0
DESCRIPTION
Bridging Setup