Rear Connections; Dc Earth Connection (Frame Ground); Mains Connection; Figure 4-3 Rear Connections - Infinite Transtector DCIPS1B-S-00-B6 Installation Manual

Installation Manual | DCIPS1B-S-00-B6 Power Supply System

4.5 Rear Connections

All cable connections for the DCIPS1B system are available at the rear of the system, see
Figure 4-3.
CAUTION Use UL-listed wires with an insulation rating to at least 90°C.
WARNING Before inserting the cable into the connector, remove as little insulation on the
cable as possible, to prevent the stranded conductor to come loose and touch any other
conductive parts.
LOAD BATTERY
CONNECTIONS CONNECTIONS
X9 X10 X6
SIGNAL
CONNECTIONS

Figure 4-3 Rear Connections

SIGNAL

4.5.1 DC Earth Connection (FRAME GROUND)

CONNECTIONS
WARNING The power system needs to be properly grounded to the rack or cabinet frame
to ensure its safe and efficient operation.
The Earth Connection (Frame Ground) of the rack is located on the rear as shown in Figure
4-3.
To connect:
1. Loosen the screw (M5).
2. Attach suitably sized cable lug.
3. Tighten the screw with torque 3.5Nm.
Recommended cable size is 6 mm

Figure 4-4 DC Earth Connections

20
LOAD BATTERY
GMT CONFIGURATION
CONNECTIONS CONNECTIONS
CONNECTIONS
X5
RS485
FRAME
GROUND
1-phase 2 x 1-phase
X9 X10 X6
.
2
+1 (208) 635-6400 | www.transtector.com

4.5.2 Mains Connection

GMT CONFIGURATION
The DCIPS1B system family is available with two options for mains connection:
First, check which mains solution is delivered and then follow the appropriate installation
AC
instructions below.
Connectors are situated on the right rear side of the system (Figure 4-3), labeled and
configured as seen in Figure 4-5.
X5
FRAME
GROUND
+1 (208) 635-6400 | www.transtector.com
WARNING Ensure that mains input is turned off before connecting. The grounding
must be connected to PE terminal as first.
CAUTION Depending on deployment region with regards to lightning strikes and
heavy inductive energy, it is highly recommended to install AC Surge Protection
Class C.
• Single-phase / Phase to Phase (USA) connection
• 2x Single-phase / Phase to Phase (USA) connection
CONNECTIONS
RS485
1-phase 2 x 1-phase

Figure 4-5 Mains Connection (viewed from rear)

Shelf Type Number of
(See product label) Rectifiers
Single-phase
2
AC Input
2 x Single-phase
2
AC Input
Table 4-1 Recommended Mains Circuit Protection
AC
Imax at Recommended
100 VAC Mains CB
18.6 A
C32A
at 100VAC
9.3 A
2 x C32A
at 100VAC
21