Table of Contents
Advertisement
Installation Manual
| DCIPS1B-S-00-B6 Power Supply System
1. About This Manual
This chapter contains an overview of the information that is presented in this Power
System Manual. This includes information on objectives, the intended audience, and the
organization of this manual. In addition, this chapter also defines the conventions used to
indicate warnings, cautions and noteworthy information.
1.1 Objectives
This manual describes the Power System, explains how to unpack and install the system,
how to perform the initial power-up and operational system check.
The information presented in this document is current as of the publication date.
1.2 Audience
This manual is to be used by installers and technicians who are preparing the site for a
new installation and installing the power system. This manual assumes that the technician
has an understanding of power systems in general and understands safety procedures for
working around AC and DC voltage.
The user of this document should be familiar with electronic circuitry and wiring practices
and have some expertise as an electronic, power, or electromechanical technician.
1.3 Document Key
This manual uses the following conventions:
WARNING This symbol indicates a situation that could cause bodily injury. Always
be aware of hazardous conditions when working in or around the power system.
CAUTION This symbol indicates a situation that might result in equipment damage.
The reader should be aware that their actions could result in equipment or data
loss.
NEED MORE INFORMATION? This symbol is used to reference information
either in this manual or in another document.
NOTE This symbol means the reader should take note. Notes are helpful
suggestions or reminders.
6
Chapter 1 About This Manual
+1 (208) 635-6400 | www.transtector.com
Abbreviation
Description
PCC
Prime Controller Card
ACX
Advance Controller Card
LVD
Low Voltage Disconnection
PLD
Partial Load Disconnection
DCIPS1B-1200
1200 W Rectifier
DB22
Distribution Drawer (4 x load, 1 x battery)
1.4 Feedback & Support
Phone: +1-208-635-6400
Web site: www.transtector.com
When contacting TRANSTECTOR, please be prepared to provide:
1. The product model number, spec number, S build number, and serial number - see the
equipment nameplate on the front panel
2. Your company's name and address
3. Your name and title
4. The reason for the contact
5. If there is a problem with product operation:
• Is the problem intermittent or continuous?
• What revision is the firmware?
• What actions were being performed prior to the appearance of the problem?
• What actions have been taken since the problem occurred?
1.5 Layout, Numbering and Printing
This manual is intended for two-sided black and white printing. Some pages are intentionally
left blank.
1.6 Disclaimer
TRANSTECTOR is not responsible for system problems that are the result of installation or
modification of the instructions provided in this manual.
+1 (208) 635-6400 | www.transtector.com
Table 1-1 Abbreviations
7
Advertisement
Table of Contents
