Table of Contents
Advertisement
Installation Manual
| DCIPS1B-S-00-B6 Power Supply System
WARNING There are potential hazards related to installing this power system. It
is important to carefully read and understand the contents of Chapter 3 System
Safety before performing system installation.
CAUTION Make sure sufficient room is left around the system, enabling optimal air
circulation and thus preventing the system from overheating. Keep vent openings
from blocking.
4.1 Introduction
This chapter provides detailed instructions for installing the DCIPS1B 1U Power System.
4.2 Unpacking
Check that the received equipment is in accordance with the packing list. Ensure that the
cabinet and the equipment have not been damaged during transportation.
Report any parts that are damaged, missing or incorrect. If possible, correct the problem
before continuing.
4.3 Tools
The following tools are required for a safe installation of the system:
WARNING Use only single-ended, fully insulated tools. Shafts of for example
screwdrivers should be insulated.
•
Anti-static hand strap.
•
Insulated screwdrivers, flat, sizes 1, 2 and 3.
•
Insulated screwdrivers, pozidrive (cross-slot), sizes 1, 2 and 3.
•
Insulated torque spanner (for battery connection).
4.4 Rack Mounting
The power system is designed for rack mounting, and the default bracket is for 19 inch rack
width. This bracket can be easily adjusted to 23" or ETSI mounting. See Figure 4-1 below.
The brackets are front mounted but can be moved by the user for center mount rack setup.
There needs to be sufficient clearance at the front for rectifier installation, and at the rear
for connections. When using side mains and DC connectors, sufficient space should be
allowed for access in this case.
18
Chapter 4 Installation Guide
+1 (208) 635-6400 | www.transtector.com
0.27 (6.8 )
19"
0.98 (25.0)
1.26 (32.0)
0.98 (25.0)
0.22 (5.6)
Figure 4-1 Dimensional Drawing (Front and Top View)
The DCIPS1B system can be easily mounted to a rack using the taptite screws to fasten the
mounting brackets to the rack as shown in Figure 4-2.
NOTE It is recommended to remove the rectifiers before installing the shelf to the cabinet
or rack.
Figure 4-2 System Mounting (19" mount)
+1 (208) 635-6400 | www.transtector.com
18.90 (480.1) [19"]
1.25 (31.75)
18.21 (462.6) [19"]
22.21 (564.2) [23"]
1.72
22.90 (581.7) [23"]
(43.6)
16.81 (426.9)
23"
0.98 (25.0)
0.59 (15.0)
0.98 (25.0)
0.55 (14.05)
19
Advertisement
Table of Contents
