Access Point Mode Setup Example; Figure 36 Windows 2000: Start - ZyXEL Communications ZyXEL ZyAIR G-220F User Manual

Access Point Mode Setup Example

This example uses the network sharing feature in Windows 2000 to bridge the wired and
wireless network when you set the ZyXEL G-220F in access point (AP) mode.
Refer to Chapter 4, "Access Point Mode Configuration," on page 50
requirements.
Steps may vary depending on your Windows version. You may need to install additional
software in Windows 98 Second Edition and Windows ME.
Configuring the Computer on Which You Install the ZyXEL G-
220F
1 Refer to
220F to operate in AP mode.
2 Click Start, Settings, Network and Dial-up Connections (or click Start, Settings,
Control Panel and double-click Network and Dial-up Connections).

Figure 36 Windows 2000: Start

3 Right-click on the icon for your wired Ethernet adapter and click Properties.
Appendix B
Section 1.7.1 "Change ZyXEL G-220F Mode" on page 23
ZyXEL G-220F User's Guide
Appendix B
for setup methods and
to set the ZyXEL G-
64