Table of Contents
Advertisement
5. Technical data
See motor and pump nameplates.
5.1 Sound pressure level, inlet pressure and temperatures
BMPX system
Sound pressure level Minimum/maximum inlet pressure
BMP hp feed pump
71.3 - 78.3 dB(A)
BM hp circulation
pump with VFD
X-Changer
* If the ambient temperature is higher than the values stated, please contact Grundfos.
** It is very important that the pump operates with the required discharge pressure to ensure proper lubrication of the pump.
6. Preparation
Before installation, the following checks should be made:
•
Check for transport damages
Make sure that the BMPX units have not been damaged
during transportation.
•
Type of system
Check that the type designation corresponds to order. See
nameplates.
•
Electricity supply
The motor and VFD voltage and frequency details given on the
nameplate should be compared with the actual electricity
supply available.
•
X-Changer
Check that all nuts are tightened.
7. Installation
The BMP hp feed pump and X-Changer are delivered separately
without any kind of base frame.
The installation must be carried out according to local regulations
and in such a way that proper and reliable operation can be
obtained.
7.1 BMP hp feed pump
The inlet port is marked with an "I" and the discharge port with an
"O".
Fig. 2
BMP hp feed pump and variable-frequency drive
70 dB(A)
Low pressure
(LP)
80 dB(A)
1/4 bar
Maximum liquid/
temperature*
0/4 bar
1/80 bar
High pressure
(HP)
–/80 bar
7.2 X-Changer
The inlet and discharge ports are shown in fig. 3.
High-pressure inlet
High-pressure discharge
Fig. 3
X-Changer
Minimum discharge
ambient
pressure**
40/40 °C
10 bar
40/40 °C
–
45/40 °C
–
Low-pressure discharge
Low-pressure inlet
5
Advertisement
Table of Contents
