The Mac Filter Screen; Figure 41 Access Point Mode: Mac Filter; Table 18 Access Point Mode: Mac Filter - ZyXEL Communications ZyXEL ZyAIR G-120 User Manual

5.4 The MAC Filter Screen

The MAC Filter screen allows you to configure the G-120 to give exclusive access to
(Accept) devices or exclude devices from (Reject) connecting to the G-120. The MAC
address is assigned at the factory and consists of six pairs of hexadecimal characters, for
example, 00:A0:C5:00:00:02. You need to know the MAC address of the device(s) to
configure this screen. See

Figure 41 Access Point Mode: MAC Filter

The following table describes the labels in this screen.

Table 18 Access Point Mode: MAC Filter

LABEL
Filter Type
Filter MAC
Address 1-16
Save
Cancel
Chapter 5 Access Point Mode Configuration
Section 3.2.2 on page 36
DESCRIPTION
Define the filter action for the list of MAC addresses in the MAC address filter
table.
Select Disable to deactivate the MAC filter feature.
Select Reject to block access to the G-120, MAC addresses not listed will be
allowed to access the G-120.
Select Accept to permit access to the G-120, MAC addresses not listed will be
denied access to the G-120.
Specify the MAC address(es) of the wireless station(s) that is allowed or denied
association to the G-120.
Enter six pairs of hexadecimal digits (separated by colons) in the range of "A-F",
"a-f" and "0-9" (for example, 00:A0:C5:00:00:02).
If you enter an invalid MAC address, once you click Save to save the values, a
warning screen will be displayed.
Click Save to save the changes back to the G-120.
Click Cancel to discard the changes.
ZyXEL G-120 User's Guide
for more information.
65