THORLABS ITC4000 Series Operation Manual page 96

ITC4000 Series
Error
Value minimum/maximum reached
Operation is not applicable
FPGA configuration error
Nonvolatile checksum error
General keyboard bootloader error
Hardware error
Calibration memory lost
Save/recall memory lost
Configuration memory lost
Self test failed
94
Description
Occurs when the range limits of the set points are
reached
Occurs in Edit Name menu if characters can't be de-
leted (with backspace) anymore
A FPGA configuration failure has occurred during the
boot procedure, please switch the unit off and on
again. If this error is shown again contact the Thorlabs
Hotline
A general EEPROM checksum error has occured,
please switch the unit off and on again. If this error will
be appeared again contact the Thorlabs Hotline
The keyboard bootloader is not running after the boot
procedure, please switch the unit off and on again. If
this error is shown again contact the Thorlabs Hotline
A device internal hardware error has occurred, please
switch the unit off and on again. If this error continues
contact the Thorlabs Hotline
The calibration data in the EEPROM is invalid, please
switch the unit off and on again. If this error is still
present contact the Thorlabs Hotline
The saved user setup data in the EEPROM is invalid,
please switch the unit off and on again. If this error is
shown again contact the Thorlabs Hotline
The last saved setup before power down is invalid,
please switch the unit off and on again. If this error is
still present contact the Thorlabs Hotline
The device self test procedure has failed, please
switch the unit off and on again. If this error continues
contact the Thorlabs Hotline
© 2018 Thorlabs