Table of Contents
Advertisement
5.6.2 CM Commands
The following table describes the
commands when you log into the CLI every time. Use the
system settings, diagnostics or configuration file maintenance.
Table 5 CM Command Summary
COMMAND
load_config
logout
ping
reset
restoreDefaults
run_app
save
scan_band
scan_set
scan_set_clear
scan_show
telnet_pass
telnet_user
version
web_admin_id
Chapter 5 Introduction to CLI
CM
<IpAddress>
<Filename{127}>
<IpAddress>
<Band{0..31}>
<index{0..4}>
<Band{1..5}> <start>
<end> [freq_offset]
<Password{15}>
<Name{15}>
<WebAdminId{15}>
commands. By default, you access the
CM
DESCRIPTION
Uploads a text based configuration from a TFTP server.
After the upload process is complete, the device executes
the commands line by line.
Exits from the CLI session.
Tests the connection to a device. Specify the IP address
of the device in dotted decimal notation (for example,
192.168.1.1).
Restarts the device.
Note: All unsaved configuration changes are
lost once you restart the device.
Resets the device back to the factory defaults.
Note: All your settings will be erased.
Executes channel band scanning.
Saves configuration changes to memory.
Sets the predefined scan band (Bitmap).
Sets the scan profile set. You can configure up to five
scan profiles in the set. The Prestige scans all profiles
when you activate band scanning.
The frequency offset (
for European scan plan.
Clears the scan profile.
Displays scan profile setting.
Sets the Telnet administrator login password.
Sets the Telnet administrator login username.
Displays the firmware version.
Sets the web configurator administrator login username.
Note: You must save the changes and restart
the device to make the changes take
effect.
P-971M User's Guide
group of
CM
commands to perform basic
freq_offset
) is only applicable
50
Advertisement
Table of Contents
