Table of Contents
Advertisement
Omni 56K Smart User's Guide
Table 5-9 Service Class 2 Commands Supported Commands (per TIA PN2388 8/20/90)
COMMAND
+FAA=n
+FBADLIN= <value>
+FBOR=n
+FBUF?
+FCIG="string"
+FCLASS=n
+FCON
+FCQ=n
+FCR=n
+FDCC=vr,br,wd,ln,df,ec,
bf,st
5-12
DESCRIPTION
Automatic answer mode parameters.
Answer as set by +FCLASS.
DCE answers and automatically determines the type of call.
Bad line threshold (number of consecutive bad lines for a bad page
parameter).Determine if Copy Quality is OK on the T.30 flow chart.
A value of 0 implies that error checking is disabled.
Phase C data bit order:
Select direct bit order.
Select reversed bit order in receiving mode for phase C data.
Buffer size. This Read Only parameter allows the DTE to determine
the characteristics of the DCE's buffer size.
Sets the local fax station ID string that is sent to polling Rx.
Service class selection. Refer to the +FCLASS Service Class 1
command in Table 5 6.
DCE automatically responds to a fax connection.
Sets the copy quality check capability parameters.
Disables the copy quality check capability.
Only check 1D phase C data.
Check both 1D and 2D phase C data.
"Capability to receive" parameter.
DCE will not receive message data or poll a remote device.
DCE receives message data or polls a remote device.
Sets the DCE capabilities parameters.
Sets Vertical resolution to Normal (98 lpi).
Sets Vertical resolution to Fine (196 lpi).
Bit rate: 2400 bit/s; V.27ter.
VALUE
n=0
n=1
0-255
n=0
n=1
n=0
n=1
n=2
n=0
n=1
vr=0
vr=1
br=0
Command Sets
Advertisement
Table of Contents
