Pre-Defined Ntp Time Servers List; Configuring Time Setting; Table 5 Password; Table 6 Pre-Defined Ntp Time Servers - ZyXEL Communications Prestige P-2002 Series User Manual

Table 5 Password

LABEL
Old Password
New Password
Retype to Confirm
Apply
Reset

3.5 Pre-defined NTP Time Servers List

The Prestige uses the following pre-defined list of NTP time servers if you do not specify a
time server or it cannot synchronize with the time server you specified.
Note: The Prestige can use this pre-defined list of time servers regardless of the Time
Protocol you select.
When the Prestige uses the pre-defined list of NTP time servers, it randomly selects one server
and tries to synchronize with it. If the synchronization fails, then the Prestige goes through the
rest of the list in order from the first one tried until either it is successful or all the pre-defined
NTP time servers have been tried.

Table 6 Pre-defined NTP Time Servers

ntp1.cs.wisc.edu
ntp1.gbg.netnod.se
ntp2.cs.wisc.edu
tock.usno.navy.mil
ntp3.cs.wisc.edu
ntp.cs.strath.ac.uk
ntp1.sp.se
time1.stupi.se
tick.stdtime.gov.tw
tock.stdtime.gov.tw
time.stdtime.gov.tw

3.6 Configuring Time Setting

To change your Prestige's time and date, click SYSTEM in the navigation panel, then the
Time Setting tab. The screen appears as shown. Use this screen to configure the Prestige's
time based on your local time zone.
Chapter 3 System Screens
DESCRIPTION
Type the default password or the existing password you use to access the
system in this field. Use up to 32 ASCII characters.
Type the new password in this field.
Type the new password again in this field.
Click Apply to save your changes back to the Prestige.
Click Reset to begin configuring this screen afresh.
P-2002 Series User's Guide
37