Table of Contents
Advertisement
V200U Valve
May 2020
Table 1. Specifications
Valve Sizes
See table 2
Valve End Connection Styles
Flangeless (all sizes) J mates EN1092-1 PN10-40
Type B raised-face flanges (see table 2) J mates with
ASME B16.5 CL150/CL300 raised-face flanges (see
table 2)
Maximum Inlet Pressure
Consistent with applicable EN 12516-1 or
ASME B16.34 ratings
Standard Flow Direction
Forward (into the convex face of the Vee‐Ball)
Dimensions
See table 4
Actuator Mounting
J
Right‐hand, standard or J left‐hand, optional, as
viewed from the valve inlet (see figure 10 and the
Actuator Mounting section)
1. The pressure/temperature limits in this manual, and any applicable code or standard limitation, should not be exceeded.
Description
The V200U Vee‐Ball valves (figure 1) with a V‐notch ball are used in throttling or on-off service. The V200U is a
flangeless construction capable of interfacing with EN 1092-1 Type B or ASME B16.5 raised face flanges. The splined or
square drive shaft connects to a variety of rotary‐shaft actuator options.
Specifications
Specifications for these valves are shown in table 1 and in the Fisher V200U Vee-Ball Rotary Control Valves Bulletin
51.3:V200U (D104550X012).
Educational Services
For information on available courses for Fisher Vee-Ball valves, as well as a variety of other products, contact:
Emerson Automation Solutions
Educational Services - Registration
Phone: 1-641-754-3771 or 1-800-338-8158
E-mail: education@emerson.com
emerson.com/fishervalvetraining
2
(1)
Standard: Ball rotates counterclockwise to close
when viewed from actuator side of valve
Optional: Ball rotates clockwise to close
Ball rotation is 90 degrees
Valve/Actuator Action
For right-hand mount actuator, the standard ball
design and actuator action is counter-clockwise to
close (CCW). The ball will rotate to the top of the
valve body when open for a horizontal pipe run with
the valve shaft positioned horizontal. J Left-hand
actuator mounting with CCW action is an option.
Left-hand actuator mounting with a special clockwise
to close (CW) ball design and actuator action is also
available to allow the ball to rotate to the top of the
valve body for a horizontal pipe run with the valve
shaft positioned horizontal.
With diaphragm or piston rotary actuator,
field‐reversible between:J push‐down‐to‐close
(PDTC) (extending actuator rod closes valve) and
J push‐down‐to‐open (PDTO) (extending actuator
rod opens valve.)
Approximate Weight
See table 3
Instruction Manual
D104548X012
Advertisement
Table of Contents
