Configuring Example With Tone Commands; Phone Number Assignment - ZyXEL Communications ISDN Terminal Adapter Omni.Net Lite User Manual

Table 22 Tone Commands
TONE COMMAND
221*n#
222*n#
310*<phone number>
[*<sub-address>]#
32d*<phone number>
[*<sub-address>]#
35d*<prefix digits> #

4.3 Configuring Example with Tone Commands

This section shows you some examples of configuring the TA using Tone commands. Refer to
Chapter 2 on page 24

4.3.1 Phone Number Assignment

Use the
***310*<phone number>[*<sub-address>]#
number to the PHONE port to which the telephone is attached. For example, dial
***130*5009001#
Chapter 4 Using Tone Commands
AT COMMAND DESCRIPTION
!pP1 Set outgoing call screen mode for the analog port.
n=0: No restriction (default).
n=1: Prohibit all outgoing calls.
n=2: Only accept the calls with the prefix in the pre-defined
list (see 35d*<prefix digits>#).
n=3: Only reject the calls with the prefix in the pre-defined
list (see 35d*<prefix digits>#).
!pP2 Select CLIP (Calling Line Identification Presentation) or
CLIR (Calling Line Identification Restriction) for the analog
port.
n=0 indicates you select CLIR and the ISDN switch will not
pass your phone number to the destination site.
n=1 indicates you select CLIP and the ISDN switch will pass
your phone number to the destination site.
!pS Assign your phone number to the analog port.
<phone number>: Enter up to 32 characters, including digits
from 0 to 9, *, #, hyphen ( -), comma (,) and (','). [','] will be
ignored.
<sub-address>: Enter up to 20 ASCII characters ranging
from "0-9"," a-z" and "A-Z".
!pId Create a list of the incoming call phone number via the
analog port.
d=0-4: phone number index.
<phone number>: Enter up to 32 characters, including digits
from 0 to 9, *, #, hyphen ( -), comma (,) and (','). [','] will be
ignored.
<sub-address>: Enter up to 20 ASCII characters ranging
from "0-9"," a-z" and "A-Z".
!pOd Create a list of the outgoing call prefix digits via the analog
port.
d=0-2
for more information about these TA features.
to assign 5009001 to the analog port.
Omni.Net Lite User's Guide
tone command to assign a phone
70