Table of Contents
Advertisement
Table 15 AT Command Sets for the Analog Port
COMMAND
\Zd=<phone
number> [/<sub-
address>]
!pA0=n
!pA1=n
!pId=<phone
number> [/<sub-
address>]
!pOd=<prefix digits> Create a list of the prefix digits for outgoing call screening on the analog port.
!pP0=n
!pP1=n
!pP2=n
Chapter 3 Using AT Commands
DESCRIPTION
Set a pre-stored phone number for the analog port.
d: 0-4
<phone number>: Enter up to 32 characters, including digits from 0 to 9, *, #,
hyphen ( -), comma (,) and (','). [','] will be ignored.
<sub-address>: Enter up to 20 ASCII characters ranging from "0-9"," a-z" and
"A-Z".
Set the device type of the analog equipment connected to the analog port.
p: enter 1 or 2 to specify the analog port.
n=0: indicates a telephone, telephone with caller ID (type 1), G3 fax or modem
(default).
n=2: indicates a telephone with call waiting caller ID (type 2).
p: enter 1 or 2 to specify the analog port.
n=0: Disable call waiting.
n=1: Enable call waiting (default).
Create a list of the phone numbers for incoming call screening on the analog
port.
p: enter 1 or 2 to specify the analog port.
d=0-4.
<phone number>: Enter up to 32 characters, including digits from 0 to 9, *, #,
hyphen ( -), comma (,) and (','). [','] will be ignored.
<sub-address>: Enter up to 20 ASCII characters ranging from "0-9"," a-z" and
"A-Z".
p: enter 1 or 2 to specify the analog port.
d=0-2
Set incoming call screen mode for the analog port.
p: enter 1 or 2 to specify the analog port.
n=0: Accept all incoming calls (default).
n=1: Reject all incoming calls.
n=2: Only accept the calls from the phone number in the list (see !pId=<phone
number> [/<sub-address>]).
n=3: Only reject the calls from the phone number in the list (see !pId=<phone
number> [/<sub-address>]).
Set outgoing call screen mode for the analog port.
p: enter 1 or 2 to specify the analog port.
n=0: No restriction (default).
n=1: Prohibit all outgoing calls.
n=2: Only accept the calls with the prefix in the pre-defined list (see
!pOd=<prefix digits>).
n=3: Only reject the calls with the prefix in the pre-defined list (see
!pOd=<prefix digits>).
Select CLIP (Calling Line Identification Presentation) or CLIR (Calling Line
Identification Restriction) for the analog port.
p: enter 1 or 2 to specify the analog port.
n=0 indicates you select CLIR and the ISDN switch will not pass your phone
number to the destination site.
n=1 indicates you select CLIP and the ISDN switch will pass your phone number
to the destination site.
Omni.Net Lite User's Guide
60
Advertisement
Table of Contents
