Table of Contents
Advertisement
Omni.Net Lite User's Guide
Table 15 AT Command Sets for the Analog Port
COMMAND
!pS=<phone
number> [/<sub-
address>]
$D99
$C0?
$C1?
$F99
$P5=<country
selection code>
3.3.3 Debug Command Sets
The AT command sets for debugging are shown in the following table.
Table 16 Debug Command Sets
COMMAND
#C0
#Dn
L6=n
L8=n
L13=n
3.4 Configuring Examples with AT Commands
This section shows you some examples of configuring the TA using AT commands.
61
DESCRIPTION
Assign you phone number to the analog port.
p: enter 1 or 2 to specify the analog port.
<phone number>: Enter up to 32 characters, including digits from 0 to 9, *, #,
hyphen ( -), comma (,) and (','). [','] will be ignored.
<sub-address>: Enter up to 20 ASCII characters ranging from "0-9"," a-z" and
"A-Z".
Upgrade firmware.
Display the charge information of the last call.
Use $C0=0 to clear the information.
Display the accumulative charge information of the calls.
Use $C0=1 to clear the information.
Reset all parameters to the factory defaults.
Set three-digit country code for caller ID signaling (FSK or DTMF).
The default is 216.
DESCRIPTION
Clear frame logs.
Display frame logs or internal task status.
n=80: display frame logs.
n=82: display C/I code (layer 1 signal) logs.
Set the level of frame logs to Q.921.
n=0: disable frame logging.
n=1: enable signal frame logging.
n=2: enable full frame logging.
Set the level of frame logs to V.120, X.75.
n=0: disable frame logging.
n=1: enable signal frame logging.
n=2: enable full frame logging.
Set the level of frame logs to PPP.
n=0: disable frame logging.
n=1: enable signal frame logging.
n=2: enable full frame logging.
Chapter 3 Using AT Commands
Advertisement
Table of Contents
