Table of Contents
Advertisement
Figure 16 RS-232 Port: Advance Setting
The following table describes the labels in this screen.
Table 8 RS-232 Port: Advance Setting
LABEL
Advance Options
Auto Answer
Wait for Conn
Power on baud rate
Power on attribute
Extended result code
Ring result code
Charge Information
Chapter 2 Using the Utility
DESCRIPTION
Set how many ringing messages the TA receives before it answers a data call
automatically.
Enter 0 to stop the TA answering a data call automatically. When there is an
incoming data call, you can press the push button on the top panel (see the
Quick Start Guide) or use the
Enter the number of seconds for the TA to wait for an answer to the data call
before dropping it.
Configure the initial baud rate after power-on.
Configure the initial attribute of the data port after power-on.
Select extended result code to show the extended command response or the
connect message to the DTE (see
basic result code (default).
Select the information you want to display for the incoming calls. Options are
no extended information (default), display calling phone number, display
user data, display calling phone number and user data and RVS-COM
format.
Omni.Net Lite User's Guide
ATA
command to answer it manually.
Table 20 on page
66). Otherwise, select
42
Advertisement
Table of Contents
