Table of Contents
Advertisement
6 The DTR LED is on. If it is off, check the HyperTerminal settings and your cable
connections.
7 Type in AT and press
now use the commands with an "AT" or "at" prefix to configure the TA. Refer to
5 on page 72
Chapter 3 Using AT Commands
•
No parity, 8 data bits, 1 stop bit, flow control set to hardware
. The terminal will response OK as shown below. You can
[ENTER]
for detailed information on AT command sets.
Omni.Net Lite User's Guide
Chapter
54
Advertisement
Table of Contents
