Setting Of Dte Port 2 Speed; Call Control Of The Dte Port 2 - ZyXEL Communications Omni TA128 User Manual

Chapter 14 - Usage of DTE Port 2
&ZOn=x

Setting of DTE port 2 Speed

The DTE speed of DTE port 2 can be configured ONLY through DTE port 1. The command
AT*An can be used for this purpose:
*A1
*A2
*A3
*A4
*A5
*A6
*A7

Call Control of the DTE Port 2

To place a call through DTE port 2, please use the ATDxxxx command. If the Calling Party
Number (the original address) is required in the outgoing SETUP message, it can be pre-stored
using the AT&ZOI=xxxx command. Once the PPP connection is established, the TA128 will
indicate the connection message with DTE speed as follows:
CONNECT 115200 PPP
Use ATV0, if numerical result code is required.
To answer a call through the DTE port 2, the MSN(or subaddress) must have been set by
the AT&ZI5=xxxx command and the number xxxx must be matched with the Called Party
Number (the destination address) of the incoming call. Please refer to the section entitled
"Answering a Call using MSN" in Chapter 4 for more information.
Write own phone number (including
subaddress, if any). The number specified
will be used as the calling party number
while dialing. Value for "n"
I = ISDN data
A= analog adapter, Phone 1
B= analog adapter, Phone 2
115200 bps (by default)
76800 bps
57600 bps
38400 bps
19200 bps
9600 bps
2400 bps
14-5