Related Manuals for RadioLink R9DS
Summary of Contents for RadioLink R9DS
- Page 1 R9DS (FHSS and DSSS spread spectrum) Radiolink R9DS, 2.4G 10 channels receiver, DSSS and FHSS spread spectrum working synchronously, use for Radiolink transmitters AT9, AT9S and AT10. SBUS and PWM signal possible working at the same time.
- Page 2 Two signal working mode: (1) PWM signal output working mode：red LED indicates PWM signal output, 9 channels Totally. (2) SBUS signal output working mode: blue/purple LED indicates SBUS signal output, 10 channels totally. SBUS and PWM signal possible working at the same time with SBUS signal output working mode.
- Page 3 3. Connect CH3 of R9DS to ESC. 4. There is a black button on the R9DS, use a thin stick press the button twice in two seconds and release, receiver light start blinking, after about 8 times blinking, match code success when...
- Page 4 3) Working current: 38-45mA（input voltage: 5V） 4) Size: 43*24*15 MM 5) Receiver integrate telemetry sensor including signal strength and voltage. Support extended engine voltage telemetry module PRM-01 and module PRM-02 can feedback GPS info, Speed, voltage etc. on AT9/AT9S/AT10 display when work with flight controller APM or PIX. 6) 4096 section precision, 0.25us per section, servo anti-shake rudder.