Fitting The Hose Connector / Connecting To The Water Supply - Walter AGW-180E Operating Manual

• Use two Allen screws (10A) to attach the
lower holster to the main frame (11).

Fitting the hose connector / Connecting to the water supply

The hose connector (9A) is suitable for connection to a½" fibre-reinforced garden
hose.
• Pull back the sleeve to release the male
connector.
• Screw the male connector on to the water inlet
(II) of the petrol pressure washer.
• Unscrew the union nut from the hose connector.
• Feed a ½" fibre-reinforced garden hose through
the union nut.
• Push the hose under the clips of the connector.
Ensure that you push it all the way onto the
connector (approx. 20mm).
• Secure the hose by tightening the union nut.
• Push the male and the female connectors together.
• Ensure the connectors are properly engaged by gently pulling the water hose.
48
11
II