Table of Contents
Advertisement
Abbr.
u o .
DATA PARITY
34
DP
35
DE
DATA ERROR
TE
TRANSFER ERROR
36
PARAMETER ERROR
PE
46
52
57
OPE
OPTION CARD ERROR
Motion A - The base shut-off occurs in the controller, the main circuit COntaCtor is
turned off, and the motor stops in the free-run state.
trouble signal contacts FA-FC are open.
For the main circuit contactor
(Note)
For the trouble signal contacts FA and FC : See Appendixes l-4 and 1-5
Name
Parity error occurs in bus linkage with the M300
series CNC.
In bus linkage with the M300 series CNC, the
shift command which exceeds the specific value
is issued from the CNC.
In the bus linkage with the M300 series CNC,
data is not correctly transferred.
A parameter value which exceeds the allowable
range is set.
the controller is turned on.)
The ambient temperature is abnormal or the main
circuit devices are overheated because an over-
load is applied or the air cooling fan stops.
The motor is overheated because an overload
is applied or the motor cooling blower stops.
lowing error exceeds the sbecific value.
In the bus linkage with the M300 series CNC,
any fault occurs in an other servo axis.
Any function which is not provided with the
option card is selected.
Description
(It is set when the power of
In additon, the
: See Appendixes l-4 and l-5
(contact MC11
(CON1 pins 11 and 12)
(Note)
A
A
A
A
A
A
A
Hide quick links:
Advertisement
Table of Contents
