Mitsubishi FREQROL-SF Troubleshooting Manual page 191

In addition, the data corresponding
to the address appears.
(Example)
state as shown in Figure 2, Gi
appears.
sed once again, [:t:
(Figure 3).
When pressing the @ switch in
the state as shown in Figure 3,
same switch once again, C: appears.
(Figure 2)
T
ta
When pressing the @ switch, data
can be rewritten.
address display LED blinks and
indicates that the data can be re-
written.
Select data using the
switches.
value, press the
To decrement the data value, press
the @ switch.
When pressing the n switch once
again, data rewrite operation is
completed.
address display LED steadily
lights rather than blinking.
When the switch is pres-
appears.
When pressing the
At the time, the
and m
UP
To increment the data
switch.
UP
At the time, the
Reference Setting and
(Note 1)
For the position
of the pushbutton
switch PBl, see
Appendix 6(l)
"SF-CA card".
(Note 2)
It is possible to
press the pushbutton
switch PBl only once
after all data write
operation is com-
pleted.