Mitsubishi FREQROL-SF Troubleshooting Manual page 202

Parameter No. on the NC screen when the equipment is linked
No. on the NC screen when the equipment is linked with
Parameter
25
G R A
3A 58 26
Number of gear
teeth on spin-
dle side
3B 27
59
G R A
3c 60 28
61
3D 29 GRB
3E 62 30
Number of gear
teeth on motor
shaft side
3F 63 31 GRB
40 64 32 GRB
Orientation
41
type
*
The parameters being asterisked are set from the NC when the equipment is linked with the
M300 series machine through the bus line.
Description
The number of gear teeth on the spindle
side against the gear 00 is converted
into hexadecimal notation and set.
The number of gear teeth on the spindle
side against the gear 01 is converted
into hexadecimal notation and set.
The number of gear teeth on the spindle
side against the gear 10 is converted
into hexadecimal notation and set.
The number of gear teeth on the spindle
side against the gear 11 is converted
into hexadecimal notation and set.
The number of gear teeth on the motor
shaft side against the gear 00 is
converted into hexadecimal notation
and set.
The number of gear teeth on the motor
shaft side against the gear 01 is
converted into hexadecimal notation
and set.
The number of gear teeth on the motor
shaft side against the gear 10 is
converted into hexadecimal notation
and set.
The number of gear teeth ont he motor
shaft side against the gear 11 is
converted into hexadecimal notation
and set.
The orientation method is set.
0: Motor built-in encoder
1: Encoder
2: Magnesensor
with
Setting range (Unit)
1 to 7FFF (Hex).
However, on the NC
screen, it is in the
range from 1 to 32767
(in decimal notation),
which is not required
to convert into hexa-
decimal notation.
The gear rate is set
by the number of gear
teeth on the spindle
side and that on the
motor shaft side.
Spindle speed
number of gear teeth
on soindle side
on motor shaft side
= motor speed
1 to 7FFF (Hex).
However, on the NC
screen, it is in the
range from 1 to 32767
(in decimal notation),
which is not required
to convert into hexa-
decimal notation.
The gear rate is set
by the number of gear
teeth on the spindle
side and that on the
motor shaft side.
Spindle speed
number of gear teeth
on swindle side
'number of gear teeth
on motor shaft side
to
= motor speed
Hexadecimal
co