System Operation; Indicator Lights - Goodwe MS Series User Manual

Solar inverter
Hide thumbs Also See for MS Series:
Table of Contents

Advertisement

Step 3:
Connect the terminal to the right position onto the inverter and screw the plate.
1. Supported DRM command: DRM0, DRM5, DRM6, DRM7, DRM8.
2. After finishing the installation, please set up power limiting function referring to section 4.2(6).
3. Pay attention to the direction of CT when wiring. CT clip should be locked tightly. White / Black
cable should be connected to Line 2, black cable should be connected to Line 1. Tighten them
with screwdriver. Make sure that CT cables are connected to the right output phase lines of
inverter when in use.
4. If not connected to CT, the inverter will show "CT Disconnect". If CT is connected reversely, the
inverter will show "CT Reverse" when it enters into on-grid status.
4.4.7 Earth Fault Alarm
The inverter complies with IEC62109-2 chapter 13.9. When earth fault occurs, the fault indicator
LED on the front cover will light up. For non-wifi inverter, , the buzzer in the inverter will keep
ringing for 1 minute every half an hour unless the fault is resolved (This function is only available
for Australia/New Zealand).
13

5 System Operation

5.1 Indicator Lights

Inverter with LCD, indicator lights in Yellow/Green/Red correspondently refer to
Indicator
Status
5.2 User Interface and Use of The Display
Set Country /Region's Safety Setting :
If display shows "Select-Country/Region", then long press (2S) the key to enter the second level
menu. Short press to browse the countries available. Please wait (10s) after choosing the suitable
country/region's safety setting according the location of installation.
1. A schematic of the display screen is shown as below:
Normal
Pac=6000.0W
Display area is divided as follows:
Line 1
Line 2
Explanation
ON = WiFi/ LAN connected / active
BLINK 1 = WiFi/ LAN system resetting
BLINK 2 = WiFi/ LAN router problem
BLINK 4 = WiFi/ LAN server problem
OFF = WiFi/ LAN not active
ON = Inverter is feeding power
OFF = Inverter is not feeding poweratthe moment
ON = Fault occurred
OFF = No fault
14

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gw5000-msGw6000-msGw7000-msGw8500-msGw10k-ms

Table of Contents