National Instruments PS-17 User Manual page 47

Appendix A Specifications
Electromagnetic Compatibility
EMC Immunity
Electrostatic discharge
Electromagnetic RF field
Fast transients (Burst)
Surge voltage on input
Surge voltage on output
Conducted disturbance
MAINS voltage dips
Voltage interruptions
Voltage sags
Powerful transients
Criterions:
A: Power supply shows normal operation behavior within the defined limits.
C: Temporary loss of function is possible. Power supply might shut-down and restarts by itself. No damages or hazards for
the power supply occur.
NI PS-17 Power Supply User Manual
Special Conditions for Hazardous Locations Use in
Europe
This equipment has been evaluated as Ex nA IIC T4 equipment under
DEMKO Certificate No. 07 ATEX 0626664X. Each module is marked
II 3G and is suitable for use in Zone 2 hazardous locations, in ambient
temperatures of -40 °C ≤ Ta ≤ 70 °C. If you are using the NI PS-17 in Gas
Group IIC hazardous locations, you must use the device in an NI chassis
that has been evaluated as Ex nC IIC T4, EEx nC IIC T4, Ex nA IIC T4, or
Ex nL IIC T4 equipment.
This product is designed to meet the requirements of the following standards
of EMC for industrial control and information technology equipment:
EN 61000-6-2
EN 61000-6-1
EN 61000-4-2
EN 61000-4-3
EN 61000-4-4
EN 61000-4-5
EN 61000-4-5
EN 61000-4-6
EN 61000-4-11
EN 61000-4-11
SEMI F47 0200
VDE 0160
Generic standards
Contact discharge
Air discharge
80 MHz to 1 GHz
Input lines
Output lines

L N

N/L PE

+ -

+/- PE
0.15 to 80 MHz
0% of 100 V
AC
40% of 100 V
AC
70% of 100 V
AC
—
Over entire load range
A-16
8 kV Criterion A
15 kV Criterion A
10 V/m Criterion A
4 kV Criterion A
2 kV Criterion A
2 kV Criterion A
4 kV Criterion A
500 V Criterion A
500 V Criterion A
10 V Criterion A
0 V , 20 ms Criterion A
AC
40 V , 200 ms Criterion C
AC
70 V , 500 ms Criterion C
AC
0 V , 5000 ms Criterion C
AC
96 V , 1000 ms Criterion A
AC
84 V , 500 ms Criterion A
AC
60 V , 200 ms Criterion A
AC
750 V, 1.3 ms Criterion C
ni.com