Functions Of The Multi-Flap-Menus - GRAUPNER mc-24 PROFI-ROM Manual

QR WK WK2 WK2
links links links rechts

Functions of the Multi-Flap-Menus:

QR :
In this line you can adjust the amount in
% by which the camber flaps "FLAP" and
"FLAP2" will be working like ailerons
when moving the aileron control stick.
In the coloumn "AILE" can the control
deviation for the ailerons also be
adjusted. The parameter values for all
three coloumns can here be adjusted
from -150% to +150% after the rele
key was pressed. Th e changed values
are reset to default values by pressing
the CLEAR –key.
Here you select the % amount by which
AiI-tr.:
the AILE, FLAP and FLAP2 respond to
the aileron trim. The control range is from
-150% to +150% with reference to the
trim lever . The changed values can be
reset to the default values by pressing
the CLEAR –key.
Diff.: (or " Aileron differential. " If the Multi-
Flap-Menu is not displayed).
In this line you adjust the differential
movement of the control surface for AILE
and FLAP and FLAP2 (providing the two
flap pairs are used as ailerons) . For the
"differential" explanation refer to the mc-
24/1-hand book, page 75.
The adjustment range from -100% to
+100% allows the correct adjustment of
WK QR
differential movement independant of the
rechts rechts
direction of servo rotation.The
key resets all to default values.
Note:
The selection of the prefix + / - changes
the differential direction. The former
change of servo connections on the
vant
receiver is no longe
Fl-pos.: Here you adjust for all th
AILE,FLAP and FLAP2 the
from –150% to +150%. As the
adjustments are flight phase dependant –
you can select for different flap positions
in the various phases i.e. landing etc.
Note:
If you - as described immediately below -
use one or more flight phase dependant
cont
for the camber flaps are recognised as
the valid "offset" or middle positions. A
flight phase specific offset adjustment in
Code 32 »Control adjust« is ther
not necessary.
CLEAR
QR
WK
WK2
0% (normal)
QR
WK
WK2
50% (differential)
100% (Split)
r necessary.
ree flap pairs
flap position
rollers, than the here adjusted values
efore
WK :
In this line you enter with the keys
or ASY the characteristic effect for the
Code 32 » Control adjust « accomplished
adjustments of input 6 to the camber flap
–
position of the ailerons "AILE" as wel
camber flap pairs "FLAP and "FLAP2
shall have.
(In the default setting is one of the two
linear sliders coupled to this input. You
can instead of the linear slider also use
switch to change the camber flap positio
within a flight phase - see also example 2
on page39)
For every pair of flaps a sym metrical or
asym metrical action can be selected.
Press the relevant
(If the travel adjustment inCode 32
» Control adjust « has remained at
+100%, control values of between 5 and
20% are normally sufficient. For the
offset adjustment see note under " Flap
pos. ")
CLEAR resets the changed values back
to the default of +100% for both pairs of
camber flaps and 0% for the ailerons.
SYM
in
l as
"
a
n
SYM - or ASY -key.
new functions 29