Front View; Ibm Ultrium 8 Front Panel - OWC Mercury Pro LTO Assembly Manual & User Manual

1.4 Front View

1. IBM Ultrium 8 drive – see Section 1.5 for details.
2. Power LED – LED will display as white if there is power but
no data connection, and as blue if there is both power and
a data connection.
- Please do not power off the Mercury Pro LTO or disconnect
the Thunderbolt 3 cable from the host during use. Doing
so will likely result in data loss and/or damage to the tape.
If you need to disconnect from the host and/or power off
the device, please use the myLTO software to make sure all
transfers are complete and then unmount the tape volume
via the Deck Controls. Please see the online manual for
more details on myLTO.

1.5 IBM Ultrium 8 Front Panel

1. Unload Cartridge button – used to rewind and then eject
cartridges, as well as to put the device into Maintenance mode,
force a memory dump, or reset the drive.
2. Ready light (green) – used in conjunction with the other status
lights, display and SCD dot to provide
3. Encryption light (white) – used in conjunction with the other
status lights, SCD, and SCD dot to provide
information.
4. Fault light (amber) – used in conjunction with the other status
lights, SCD, and SCD dot to provide
5. Single Character Display (SCD) – used in conjunction with the
status lights and SCD dot to provide
6. SCD dot – used in conjunction with the status lights, and SCD
to provide drive status
OWC Mercury Pro LTO
drive status information.
drive status
drive status information.
drive status information.
information.
6
3
1
2
1
2
3
5 4
Introduction