FlyTek Zip Operation And Maintenance Manual page 12

The brewing head and the spout should be cleaned weekly. To do this we must proceed to make a supply without
pod. Place a big glass under the delivery spout and press the coffee delivery switch (Ref. D); after about 5 seconds
the hot water will start to flow off. After about 2 minutes press again the coffee delivery switch to shut off hot water.
Do not use the dishwasher to clean the machine or its components because they will be
irremediably damaged. Moreover, do not use solvents and/or abrasive substances.
It is possible to clean the machine only when it is switched off (put the power switch in "zero") and has cooled
down, with the exception of the brewing head. Wipe body of machine with a damp cloth. Remove the water
container (Ref. A) and wash in warm soapy water, using a soft sponge and must be thoroughly dried before its
reinsertion. If it is necessary to clean the water tank, use hot water.
If a cleaning soap is used to clean the water tank, make sure to rinse it scrupulously,
because any potential chemical residue in the tank can cause the food poisoning.
Repair service should be performed only by competent and authorized persons. If you cannot solve problems with
the help of this table, contact your authorized reseller.
PROBLEM
Coffee brewing is insufficient or
impossible
The supplied drinks are cold even
if the temperature ready-light (Ref.
C) is lighted up
Pump makes loud noise
Coffee has little/has not creamy
froth
During the repair service, it can be dangerous to use non original spare parts and/or not
observe the terms of production of the manufacturer.
If the water in the tank is missing it can burn the pump and put the machine in short circuit.
KEEPING BREWING HEAD AND SPOUT CLEAN
KEEPING THE COFFEE MACHINE CLEAN
ANOMALIES AND POSSIBLE SOLUTIONS
POSSIBLE CAUSE
Water tank is empty
The coffee is too fine
Ceramic cups are cold
The warming system is
defective
Water tank is empty
The coffee is ground too
coarsely
The coffee is not fresh
The water is in the tank for
several days
SOLUTION
Fill the water tank (page 10)
Use a new pod. Contact the supplier of
pods
Preheat the cups with hot water or use
disposable cups
Contact the dealer
Fill the water tank (page 10) and press
the switch (Ref. D) repeatedly
Use a new pod. Contact the supplier
of pods.
Use a new pod. Contact the supplier
of pods.
Change the water in the tank (page 10)
12