Factory Settings; Software Version; Internet Settings; Wps Connection - Nordmende Transita 120 IR Instruction Manual

10.5 Factory settings

Select System settings > Factory settings, to reset the Transita 120 IR back into its delivery
status. Calling up Factory settings resets all changes and settings you may have made!

10.6 Software version

Under Menu > SW version you will see the currently installed software version.

10.7 Internet settings

Select System settings > Internet settings, to establish a connection to a WLAN
>
network.
In this menu you will find some settings and information about Internet connection.
Select Network wizard to establish a WiFi connection.
>
The network wizard shows you all the WiFi stations within range.
Select the WLAN network you know and select WPS skip.
Then enter the appropriate password using the displayed keyboard. Finish by
selecting. If the password entered is correct, a connection to the network is now
established. The signal bar in the status bar of the display indicates whether the
connection has been established.
Select
If you make a typing error you can delete the last letter entered using

10.7.1 WPS connection

Select PBC WLAN set up if your router has the WPS 2.0 function. This establishes a
>
direct connection to the router without having to enter the WLAN password.
If you activate WPS on your router, please observe its instruction manual.
> Start WPS on your router by pressing the corresponding button.
After you have called up the PBC WLAN Set up, press the Scroll&Select/Snooze knob
>
button to establish the WPS connection.
to abort the data entry.
.
Page 71
DE
EN
NL
FR
PL