Table of Contents
Advertisement
Installation Manual
| DCIPS2B-S-00-B11 Power Supply System
Figure 4-18 Alarm Connection
NOTE The alarm configuration will be dependent on your system configuration.
NEED MORE INFORMATION? For detailed information regarding Alarm connection see
Appendix A, Installation Drawing.
4.9 Symmetry Connection
The ACX controller can supervise 4-block symmetry measurements on 4 battery branches.
NOTE Symmetry cables are pre-connected to the system.
NOTE Multi Purpose inputs which are not used for symmetry measurement can be
reconfigured to user defined analog inputs.
1. Insert a suitably sized cable lug into one pole of the inter-block connection plate. Fasten
the lugs and plates to individual battery poles.
2. For 2-block battery symmetry measurement fix one wire of the symmetry cable to the
cable lug in the mid-point of the battery string, see Figure 4-19.
36
4
4
+1 (208) 635-6400 | www.transtector.com
+1 (208) 635-6400 | www.transtector.com
Figure 4-19 2-block Symmetry Measurement (for illustration only)
For 4-block measurement fix the 3 wires (red, green and blue) of the symmetry cable to
individual cable lugs. Color coding of the cables must be followed for proper symmetry
measurement, see Figure 4-20.
Figure 4-20 4-Block Symmetry Measurement (for illustration only)
NOTE The interblock Connection Kit is not delivered with the system.
4.10 Temperature Sensor Connection
NOTE The power system is usually delivered with pre-connected temperature
sensor cables. If not, use a three-pin plug and connect according to the
Installation
Details.
Battery Temperature
Temperature sensor 1 measures the temperature of the battery bank while the controller
adjusts the float charge voltage according to the temperature compensation factor set in the
controller. This factor must be set in the controller according to the battery manufacturer 's
recommendations.
Appendix A -
37
Advertisement
Table of Contents
