Table of Contents
Advertisement
Installation Manual
| DCIPS2B-S-00-B11 Power Supply System
Fasten the temperature sensor in the middle of the battery bank, Figure 4-21.
Temp. Sensor
Figure 4-21 Temperature Sensor Connection
NOTE The temperature compensation factor can be set only for temperature sensor 1.
Ambient Temperature
Temperature sensor 2 allows a second temperature reading, most commonly the ambient
temperature around the system. Place the sensor as required.
The temperature is displayed in the External Measurements menu in the ACX controller or
in PowCom™ software.
NOTE Temperature sensor 2 can be activated only in the systems with the ACX
controller installed.
4.11 Connecting an RS232 Communication Cable
The controller can communicate with an external device such as a network interface card
through an RS232 connection.
1. Remove the top cover of the controller.
2. Connect the RJ45 port of the RS232 communication cable to the RJ45 port marked with
RS232 on the internal communication board.
3. Pull out and fix the DB-9 connector of the RS232 communication cable for application.
4. Re-install the top cover of controller.
38
+1 (208) 635-6400 | www.transtector.com
+1 (208) 635-6400 | www.transtector.com
Figure 4-22 RS232 Connection
4.12 Rectifier Installation
NOTE Ensure that the rectifier handle is in the OPEN position (forms 35-40° angle with
rectifier body) before inserting the module into the slot.
Rectifier module should be installed starting from the bottom left position in the rectifier shelf.
1. Place the rectifier module in the mounting slot with handle facing out.
2. Slide the rectifier module into the slot until it contacts the interface connection at the rear
of the shelf, Figure 4-23 #1.
3. Fully insert the rectifier by pushing the handle towards the shelf. The rectifier handle will
rise up and lock the rectifier into the position, Figure 4-23 #2.
4. Repeat steps 1 to 3 if more rectifiers are to be installed.
1
Figure 4-23 Rectifier Installation
2
39
Advertisement
Table of Contents
