Bowflex RevolutionXP 001-7057 Assembly Instructions Manual page 27

Step 24 Assemble Leg Extension
Parts:
• Foam Roller Pads Pad (Box 4)
• Roller Tubes (Box 4)
• Leg Extension Assembly (Box 4)
• End Caps (Box 4 Hardware Card)
• Leg Extension Pin (Box 4 Hardware Card)
24-1 Slide the Roller Tubes through the
holes in the Leg Extension Assembly
followed by the Roller Pads and End Caps.
24-1 Place the Leg Extension Pin through Leg Extension
Assembly and Pivot Tube.
Install the Leg Extension Assembly by pulling
down on the Pop-Pin under the Seat and inserting
the Leg Extension into the bracket. Slide the Leg
extension to the desired position and screw the
Pop-Pin tightly into place.
Leg Extension Assembly
Seat Pad
Pop-Pin
Assembly
Leg Extension Pin
Roller Pad
Leg Extension Assembly
Roller Tube
Pivot Tube
End Cap