Advertisement
Step 21 Install Pulleys
Parts:
• Pulley Components (Box 3)
Tools:
• Screwdriver
NOTE: Remove and discard the hex nut to
disassemble the Pulley components.
21-1 Place a Spring Cap over a threaded hole in a
Stabilizer and screw the Hook Bolt into the
hole ONLY about three turns. (Figure A)
21-2 Place the Spring down over the Hook Bolt.
Compress the Spring and hook the Eyelet
under the Pulley to the Hook Bolt. (Figure B)
21-3 Place a screwdriver through the Spring and
Hook Bolt on the Pulleys and tightly screw
them into the Stabilizers. (Figure C)
NOTE: Place the pulleys with the
pre-installed cable closest to the main frame.
Pulley
Hook Bolt
Eyelet
Spring
Figure B
Assembly
Pulley
Hook Bolt
Spring
Spring Cap
Hook Bolt
Spring Cap
Hex Nut (discard)
Figure A
Screwdriver
Figure C
Advertisement
