Adapting Blower For Outside Back Exhaust - Haier QVM7167 Installation Instructions Manual

ADAPTING BLOWER FOR
C4.
OUTSIDE BACK EXHAUST
5 The fan needs to be rotated counter clockwise
180 degrees and rolled 90° to the right to be in the
correct orientation, keeping the blower part of
the fan where the air comes out at the top of the
fan. The wire needs to be reinserted into the case
housing once it has been oriented correctly.
Before Rotation
Back of
Microwave Oven
Before Rolling
Back of
Microwave
Oven
Replace screw on the back of the unit.
6
Slide the vent damper on the back of the unit with
7
the hinge at the top.
Slide
exhaust
adaptor into
guides on
microwave
oven rear.
8 Slide the Blower cover onto the top of the blower
plate opening
Blower Cover
Screw
24
Installation Instructions
(cont.)
After Rotation
Back of
Microwave Oven
After Rolling
Back of
Microwave
Oven
Screw
Damper
(hinge side up)
Exhaust
Adaptor
Locking Back of
Tabs Microwave
Oven
Blower Cover
Blower Plate
ADAPTING BLOWER FOR
C4.
OUTSIDE BACK EXHAUST
cont
Slide the blower plate back onto the microwave
9
by placing the side tabs into the slots and pushing
gently until the back tab is seated into the rear slot,
replace the 3 blower plate screws. Replace the
blower motor screw.
Blower Motor Screws
Blower Cover
31-7000069 Rev. 1