Haier QVM7167 Installation Instructions Manual page 16

ADAPTING MICROWAVE BLOWER
A4
FOR RECIRCULATION
5
Slide the Blower Cover onto the top of the Blower
Plate opening.
Blower Plate
Slide the blower plate back onto the microwave
6
by placing the side tabs into the slots and pushing
gently until the back tab is seated into the rear slot,
replace the 3 blower plate screws. Replace the
blower motor screw.
Blower Plate Screws
Side Tab
Side Slot
16
Installation Instructions
Blower Cover
Rear Tab
Blower Motor
Screw
Rear Slot
INSTALLING THE CHARCOAL
A5
FILTER
Open the door.
1
Push the "Push" area on charcoal filter cover at center
2
of the grille.
Insert the top of the filter up and into the grooves on
3
both sides of the inside of the top opening. Once you
have cleared the bottom tab, push the bottom of the
filter in until it restes in place behind the tab.
Filter
Close the charcoal filter cover.
4
Close the door.
5
Bottom Tab
31-7000069 Rev. 1