Haier QVM7167 Installation Instructions Manual page 20

B4.
ADAPTING BLOWER FOR
OUTSIDE VENTILATION
Slide the damper from left to right into the tabs on the
5
blower plate. The yellow tape on the damper should
be facing away from you.
Blower
Plate
Remove the yellow tape from the damper. Make sure the
damper pivots easily before mounting microwave oven.
NOTE: You will need to make adjustments to assure
proper alignment with your house exhaust duct after
microwave is installed.
Slide the blower plate back onto the microwave by
6
placing the side tabs into the slots and pushing gently
until the back tab is seated into the rear slot, Replace
the blower plate 3 screws.
Side Tab
Side Slot
Rear Slot
Slide the blower cover down on the back plate of the
7
microwave. Replace Blower Cover screw.
Skip to step B6.
Black Plate of Microwave
20
Installation Instructions
Damper
Blower
Cover
Damper
Blower
Plate
Rear Tab
Blower Motor
Screw
Damper
Blower Cover
Blower Cover
Screw
ASSEMBLE AND INSTALL
B5
ADAPTOR
Blower
Plate
1
Place the microwave oven in its upright position, with
the top of the unit facing up and the front of the unit
facing toward you.
Remove the screw on the back side of the blower
2
plate and raise the blower plate off of the microwave.
Slide the damper from left to right into the tabs on
3
the blower plate. The yellow tape on the damper
should be facing away from you.
Remove the yellow tape from the damper. Make sure
that the damper pivots easily before mounting
4
microwave oven.
You will need to make adjustments to assure proper
alignment with your house exhaust duct after the
5
microwave oven is installed.
Position the blower plate with damper and blower
cover back on the microwave and secure it with the
screws that were removed.
Damper
Blower
Cover
31-7000069 Rev. 1