Haier QVM7167 Installation Instructions Manual page 19

B2
USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes for the top support screws,
a hole large enough for the power cord to fit through,
and a cutout large enough for the exhaust adaptor.
• Read the instructions on the TOP CABINET
TEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the TOP
CABINET TEMPLATE.
Wear safety goggles when drilling
CAUTION
holes in the cabinet bottom.
B3
CHECK BLOWER MOTOR
ORIENTATION
The blower fan blade opening should be facing the top of
the microwave. If the fan opening is already facing the top
of the microwave, skip to Step B5. Otherwise, continue
to Step B4 to adjust the blower orientation.
ADAPTING BLOWER FOR
B4
OUTSIDE VENTILATION
Under the condition of the blower cover is installed on
1
the top of the microwave, remove the screw holding
the blower cover and remove the blower cover from
the blower plate by sliding it right.
Blower Cover
Screw
31-7000069 Rev. 1
Installation Instructions
Blower Cover
B4
ADAPTING BLOWER FOR
OUTSIDE VENTILATION
Remove the 3 screws securing the blower plate, and
2
remove the blower plate from the outer case by sliding it
toward the back of the microwave and pulling up.
Blower Plate Screws
Blower Plate
Carefully pull out the blower unit. The wires will extend
3
far enough to allow you to adjust the blower unit.
Rotate 90°
Roll the blower so that the fan blade openings are facing
4
the top of the oven. Place the blower back into the
opening.
Fan Blades
Wires
NOTE: Make sure the wires remain routed through the
openings in the motor frame. To avoid damage to the
fan motor wiring, insert motor carefully such that the fan
motor wiring does not contact the microwave power cord
bracket.
Risk of Electric Shock
WARNING
Can cause injury or death. Do not pull
or stretch the blower unit wiring. Make sure the wires are
not pinched.
Back of
Mircrowave
Back of
Mircrowave
19