Haier QVM7167 Installation Instructions Manual page 15

A3
CHECK BLOWER MOTOR
ORIENTATION
The blower fan blade opening should be facing the front
of the microwave. If the fan opening is already facing
the fornt of the microwave, skip to Step A5. Otherwise,
continue to Step A4 to adjust the blower orientation.
ADAPTING MICROWAVE BLOWER
A4
FOR RECIRCULATION
1 Remove the screw holding the blower cover and
remove the blower cover from the back plate of
microwave by sliding it up.
Blower Plate
Back of Microwave
Remove the screws securing the blower plate and
2
remove the blower plate from the outer case by
sliding it toward the back of the microwave and pulling
it up.
Blower Plate Screws
Blower Plate
31-7000069 Rev. 1
Installation Instructions
Blower Cover
Blower Cover
Screw
ADAPTING MICROWAVE BLOWER
A4
FOR RECIRCULATION
Carefully pull out the blower unit. The wires will extend
3
far enough to allow you to adjust the blower unit.
Fan Blades
Wires
Roll the blower so that the fan blade openings are facing
4
the front of the oven. Place the blower back into the
opening.
Rotate 90°
NOTE: Make sure the wires remain routed through the
openings in the motor frame. To avoid damage to the
fan motor wiring, insert motor carefully such that the
fan motor wiring does not contact the microwave power
cord bracket.
WARNING
Risk of Electric Shock
Can cause injury or death. Do not pull or stretch
the blower unit wiring. Make sure the wires are not
pinched.
Back of
Mircrowave
Back of
Mircrowave
15