Haier QVM7167 Installation Instructions Manual page 17

MOUNT THE MICROWAVE OVEN
A6
CAUTION
To avoid the risk of personal injury
(back injury or other injuries due to excessive
weight of the microwave) or property damage, you
will need two people to install this microwave.
WARNING
Risk of Electric Shock. Can cause
injury or death: If installing unit with metal cabinets,
cover the edge of the power supply cord hole in the
cabinet with the power supply cord bushing.
IMPORTANT: If filler blocks are not used, case
damage may occur from overtightening screws.
NOTE: When mounting the microwave, thread power
cord through hole in bottom of top cabinet. Keep it
tight throughout Steps 1–3. Do not pinch cord or lift
microwave oven by pulling cord.
1 Lift microwave, tilt it forward, and hook slots
at back bottom edge onto four lower tabs of
mounting plate.
Power Cord
Rotate front of microwave oven up against cabinet
2
bottom.
31-7000069 Rev. 1
Installation Instructions
A6 MOUNT THE MICROWAVE OVEN
(cont.)
Insert 3 self-aligning screws (
3
outer top cabinet holes. Turn two full turns on each
screw.
Cabinet Front
Cabinet Bottom Shelf
Self-Aligning Screw
Microwave Oven Top
Self-Aligning Screws
4 Tighten the three screws to the top of the
microwave oven. (While tightening screws, hold
the microwave oven in place against the wall and
the top cabinet.)
5
Install grease filters. See the Owner's Manual
packed with the microwave oven.
") through
1 4 1 4
Filler Block
This distance
can NOT
Equivalent
exceed 2"
to Depth
to ensure
of Cabinet
proper
Recess
installation
17