Table of Contents
Advertisement
(8) After a period of time, check the PEAK TABLE and estimate whether
the signal of interest is logged. If the answer is yes, press the save button on
the soft menu to save the table.
The table will be saved to TF card (if equipped) as well as the VFO
temporary frequency list. In Receiver mode, enter VFO and access the list, then
use knobs or left/right key to move the frequencies to be selected, which
correspond to top 100 strong signals that have just been saved. For frequency
of interest, it can be saved to channel list separately.
The data in this temporary frequency list will be refreshed if the PEAK
TABLE function is used and saved again.
(9) Frequency of interest can also be selected directly on PEAK TABLE, and
be sent to receiver. This operation sends the frequency to VFOB, the the
current B channel frequency will be overwritten, while other settings remain
the same. The drawback of this method is that if the frequency needs to be
selected again, the user need to re-enter the PEAK TABLE to operate.
(10) If the analogical demodulator is not capable of demodulating the
signal, press key combination SHIFT+2 to record the IQ data for future
analysis.(a TF card needs to be installed in advance).
6.FAQ
Advertisement
Table of Contents
